Escient EWP-2000 V2 Bedienungsanleitung PDF herunterladen (Seite 101)

Chapter 18: The Infrared Code Database

Step 9:

In the last step you can verify and test the learned code

by selecting the code in the tree and click on the “Send

IR-Code“ button.

Here you can also verify and edit the IR code manually

if you find any drop outs in the signal.

The red part of a signal is the looped signal, the green

part a single shot signal.

There exist also IR codes which start with a single

sequence and end with a looped sequence.

The looped sequence will be repeated until the soft or

device button is released.

If the signal of the original remote control has to much

drop outs, RC-II can't automatically detect the looped

area of the IR signal.

If your mobile device behaves sluggish or freezes while

sending a IR signal, the IR code may be very long (>3s). Try to relearn this IR code again or make

only very short button presses on your original remote control while learning.

Test the code with “Send IR-Code”

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 127 128

Keine Kommentare

Escient EWP-2000 V2 Bedienungsanleitung Seite 101