Escient EWP-2000 V2 Bedienungsanleitung PDF herunterladen (Seite 92)

Chapter 17: Learning new Infrared Commands

17 Learning new Infrared Commands

If your device has a built in IR/IrDA port you can send IR commands to your home equipment and

learn new commands from your original remote controls.

Most PocketPC and mobile phone devices until 2007 have a IrDA port included because of a

requirement from Microsoft for these device types.

IrDA is primary used to connect the Windows CE device via ActiveSync to a laptop, IR printer or to

use a mobile phone for a internet connection via GSM/GPRS/EDGE/UMTS.

On more recent Windows CE devices IrDA was substituted by Bluetooth.

Low priced devices with IrDA port are available at eBay. We have listed some tested Windows CE

devices in chapter 21, “List of Tested Devices with included Infrared Port“

RemoteControl II supports three ways to learn new IR commands:

1. Using the quick learn mode described in chapter 17.1, “IR Quick Learn Mode”

2. Creating new devices and learning in the IR database described in chapter 18.1, “Creating

new IR Database Entries”

3. By entering CCF IR hex codes into the IR database described in chapter 18.2, “Importing

CCF IR Hex Codes”

For learning new IR codes the IrDA COM port has to be first selected in the settings dialog (see

chapter 7.1, “Infrared / IrDA- Port Settings”).

17.1 IR Quick Learn Mode

The easiest way to learn new IR codes from your original remote control is the “quick learn” mode.

For this, the panel page layout should be completed and all required soft buttons already included.

To start the IR quick learn mode click on

the menu “Edit->IR Quick Learn...”.

Start the IR quick learn mode

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 127 128

Keine Kommentare

Escient EWP-2000 V2 Bedienungsanleitung Seite 92