Escient FireBall H-40 Remote control Bedienungsanleitung PDF herunterladen (Seite 34)

TheaterTouch Designer

RK3 NETWORK TAB

DHCP

1. Check this box to configure the device's network interface

using DHCP. You must have a DHCP server (such as a router

or cable/DSL modem) on the network for this to work. In

most cases, this is the option you should use.

MANUALLY CONFIGURE NETWORK SETTINGS

2. Use this selection to configure the device's network interface

using a static IP address. The values can be obtained by con

tacting your ISP or your network administrator.

- Enter the device's static IP Address

- Enter the network's:

Netmask

Gateway IP Address

DNS Server 1

DNS Server 2 (If only one is available, leave blank)

ALLOW THE DEVICE TO BE PROGRAMMED OVER THE NETWORK

3. Check this box to allow the device to be programmed remotely via the device's ethernet interface. If

you uncheck this box you will have to use a direct USB connection to update the device's programming.

Unchecking this box provides increased security by preventing the device's programming from being altered

over the network.

4. Select OK to confirm all selections.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 144 145

Keine Kommentare

Escient FireBall H-40 Remote control Bedienungsanleitung Seite 34