Escient FireBall H-40 Remote control Bedienungsanleitung PDF herunterladen (Seite 93)

OUTPUT TAB (ALL DEVICES)

The Output Tab allows the selected output mode for the selected button to be set to a mode that is different from

the device default.

OUTPUT MODE

1. Select Use Device Default to set the output type for the selected

button to the system default. The system default is selected with

the Properties command in the Device menu.

2. Select Standalone to force the selected button to transmit

IR directly from the device, regardless of the default setting.

Selecting this option will also cause any macro on the selected

button to run on the device instead of the control system. Use

this setting if you want the device to send out IR from the

device and an RF trigger to the Control Processor to run a sys

tem macro.

3. Select RF Trigger Codes for Control system to force the selected

button to transmit RF to the control system regardless of the

default setting. Selecting this option will also cause any macro on

the selected button to run on the control system instead of the

device.

4. Select IR Trigger Codes for Control system to force the selected

button to transmit IR for the control system regardless of the

default setting. Selecting this option will also cause any macro

on the selected button to run on the control system instead of

the device.

Note: These settings are normally not changed unless the system contains a mixture of RF and IR commands.

5. Choose the control system that the command for the selected button will trigger.

Note: This setting is only changed when more than one control processor is included in the system.

6. Choose OK to confirm the new settings.

Chapter 6. Working with Buttons

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 144 145

Keine Kommentare

Escient FireBall H-40 Remote control Bedienungsanleitung Seite 93