Escient FireBall H-40 Remote control Bedienungsanleitung PDF herunterladen (Seite 53)

T2+ GENERAL TAB

ENABLE BEEPER

1. Check this box to enable the beeper. If this box is

checked, the remote control will beep every time a but

ton is pressed. This option is enabled by default.

ENABLE TILT SWITCH

2. Enabling the Tilt Switch allows the internal tilt switch

to turn on the display and button backlight when the

remote control is handled. This option is enabled by

default.

POWER DOWN TIME

3. Adjust the amount of time the unit stays awake after

the remote is set down after use. The time is variable

from 1 second to 60 seconds (default is 10 seconds).

During sleep mode, the remote control uses virtually

no battery power.

BACKLIGHT

4. Choose one of the two backlighting options, on when

device is active or only on when the backlight keys is

pressed.

FRAME SCROLLING RATE

5. Slide this control to set how fast the frames scroll left and right when the frame scroll arrows are pressed.

FRAME SCROLLING WRAPS AROUND EDGES

5. Select the frame scrolling wraps around at edges check box and the page frames will cycle back to the first

or last frame when using the frame right and left arrows.

SECURITY

6. Passcode: (default is 0000) Allows you to set the passcode that the Clear All function on the remote's con-

trol panel page as well as the Secured Button Option function that is available on all buttons.

7. Choose OK to confirm the new settings.

Chapter 4. Working with Devices

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 144 145

Keine Kommentare

Escient FireBall H-40 Remote control Bedienungsanleitung Seite 53